-
Welcome to RCTalk! 🚀
Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!
- ✓ Friendly & passionate RC enthusiasts
- ✓ RC tips & troubleshooting
- ✓ Buy, sell & trade RC gear
- ✓ Share builds & upgrades
Hpi Mt2 Ss?
- Thread starter MT2Jumper
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
You're an absolute gent!
I actually got the part no of someone else too, but seeing as I can't find it anywhere your confirmation was still needed.
I also discovered that Racers Edge do the exact same part, so I ordered those instead.
Thanks.
I actually got the part no of someone else too, but seeing as I can't find it anywhere your confirmation was still needed.
I also discovered that Racers Edge do the exact same part, so I ordered those instead.
Thanks.
no prob.
so far this truck is GREAT.
Still breaking it in.
Friend got a 4.6 savage the sametime i got my kit.
Once we've both tuned, we gonna race... i'm running temps around 230ish... figured i would take it to about 250 degrees.. so its got some balls left in it.
Right now, i haven't maxed it out, but from what i've seen, it pops wheelies when you get on the throttle hard at a stop. It rocks!!!
A few pictures of the truck....
so far this truck is GREAT.
Still breaking it in.
Friend got a 4.6 savage the sametime i got my kit.
Once we've both tuned, we gonna race... i'm running temps around 230ish... figured i would take it to about 250 degrees.. so its got some balls left in it.
Right now, i haven't maxed it out, but from what i've seen, it pops wheelies when you get on the throttle hard at a stop. It rocks!!!
A few pictures of the truck....
Mt2 Ss
The SS will pull the front end off the ground in mid throttle. Sometimes it is very difficult to keep it from flipping backwards. Once it starts it is on it back almost instantly. I have Masher 2000 tires on the truck at the moment, but the dirt bones are the same way. I also installed the hpi racing clutch and a 13t clutch bell. The top speed is difficult for me to control on a track and the tall mashers work a little better with the lower ratio.
Anybody have any ideas on keeping these tires glued. I keep slinging them off. They swell like crazy when I throttle up.
The SS will pull the front end off the ground in mid throttle. Sometimes it is very difficult to keep it from flipping backwards. Once it starts it is on it back almost instantly. I have Masher 2000 tires on the truck at the moment, but the dirt bones are the same way. I also installed the hpi racing clutch and a 13t clutch bell. The top speed is difficult for me to control on a track and the tall mashers work a little better with the lower ratio.
Anybody have any ideas on keeping these tires glued. I keep slinging them off. They swell like crazy when I throttle up.
Attachments
Last edited:
greenwing7
RCTalk Addict
- Messages
- 729
- Reaction score
- 0
- Points
- 0
- RC Driving Style
damn your old lady let you put your trucks on the table!
