Hpi cuda aar body

[wacmartin]

I got an hpi cuda aar body for a vta car it's part number 17510. Anyways it looks like there's 2 pieces to this body on the mould, actually I'm pretty sure there is because there's a gap of the rougher looking lexan between the body and what looks like the rear end. I want to know to cut it out as 2 pieces our 1 and how do I attach maybe bend if its 1 I'm not sure. If anyone has a link in how to do this could you post it up cause I searched and can't find it. The body came with servo tape so I'm thinking 2 pieces and some nuts and bolts but from search I understand that those are to attach the wing.

It's my first after market body! I'm still a newb to a great aspect of this hobby lol.

 

[Lessen]

Yes, cut them out seperately. I can't recall exactly how it's laid out on the mold, but basically the rear end fits where it's supposed to and adds the authentic underbody looking curves. There will be a tab on the "bumper" that slids inside of the quarter panel of the main body. Servo tape that and possibly the width long tab that comes up and runs along the rear of the deck lid (or that may be the Challenger, can't remember).

 

[WrenchHead]

That is about it. But learn from my mistakes. 1st time out the rear end will pop off with any kind of rear impact. I used Shoo Goo to secure my rear section and my wing. And I filled in my front grill and light area. I built the Camaro version of this body. VTA is the short course of onroad racing.

Before the season

After the season