• Welcome to RCTalk! 🚀

    Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!

    • ✓ Friendly & passionate RC enthusiasts
    • ✓ RC tips & troubleshooting
    • ✓ Buy, sell & trade RC gear
    • ✓ Share builds & upgrades

how do i oil my engine?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
take the glow plug out and spray some after run oil or some wd-40 in the glow plug hole. just a short burst. then press the EZ-start button for a few seconds with the truck upside down. take the air filter off and spray a short burst in the carb at WOT. and if you want you can take your back plate off and put a few drops on the bottom of the connecting rod where it goes on the crank. hope this helps.....
 
adeezy9183 said:
take the glow plug out and spray some after run oil or some wd-40 in the glow plug hole. just a short burst. then press the EZ-start button for a few seconds with the truck upside down. take the air filter off and spray a short burst in the carb at WOT. and if you want you can take your back plate off and put a few drops on the bottom of the connecting rod where it goes on the crank. hope this helps.....
Click to expand...

helped alot. thanks
 
There's no reason to take the backplate off for after run procedure. Just a couple of drops in the head and in the carb. Turn it over for 5-10 seconds and your ready to run next time. Always put the piston at the bottom of the stroke as soon as you shut the engine off. Move the flywheel to the loose spot.
 

RC Builds

Back
Top