How do I install resonator pipe -T-maxx 2.5

[Austin]

So I bought the resonator exhaust pipe and It came with no instructions and I'm not completely sure on how to install it.. Could anyone give me a guide or tell me how to do it, A video, anything. Heres a pic of the stuff it came with:
Thanks, Austin

 

[Suicide]

look a your stock pipe it should have a screw off an metal spring looking thing take that screw off and take your stock pipe off the header and the resonater should bolt right back in to that screw but you probly need put that gasket thing on and put the wire ties on it

 

[flandersander]

yeah, he's got it. You take the screw off the "bottom" of the pipe (the part that is closer to the front) and take off the cable tie that attatches the stock pipe to the rubber coupler. Then simply put the resinator pipe into the coupler the same way the stock one did, then screw it in again, the same way. set your needles back to factory settings and retune as the new pipe will be slightly different in performance. And then kick ass on your biddies stock tmaxxes. =]

 

[Suicide]

wow i got i right I've never done it before awesome I'm a fricken genius

 

[Austin]

I don't think you guys exactly understand what I've got here, This is what I am installing: Please tell me what to do I'm clueless!

 

[Austin]

Bump!!!!

 

[RC Addict]

OK. See the little curved pipe? Use the large red rubber gasket to attach the large end of the pipe to the engine using the large spring that is already on the existing exhaust. It goes around the head.

Then use the little black rubber gasket between the pipe and the exhaust and attach the two with the three supplied springs.

You mount the little metal support rod with the loop in the end on the frame where the existing mount is and thread it through the little hole in front of the exhaust with the supplied set screw used to secure it.

Good luck!

 

[Austin]

Ohhhhhhh thanks so much that helped alot.. but one problem, my old exhaust didn't use a spring to hold it to the engine, it used allan screws... And About the shiny rod with the circle at the end... where does that go? a Picture would be verrrry nice.