Hmmm ??

[Guccii]

He all I'm new to the whole r/c thing been reading a lot of your post on this site, but i have ran into a problem while adjusting me carb the HSN came loose and the whole part came out, i tried putting it back in but when i tried to tighten the bolt it doesn't tighten i can still just pull out the whole HSN screw adjustment piece right out..!! any info on how to get it back in would be much apprenticed!

 

[NitroRC4Life]

If you tighten it back up, and then you can pull it back out then the threads are definitely stripped. I really don't know you can fix this but you must have tightened down the carb too much and stripped the threads, or put it in and not have lined it up properly to thread it correctly.

 

[Guccii]

ya i believe i might have striped the threads were the hsn screws into the crab.. hmm what to do

 

[Macguyver]

ya i believe i might have striped the threads were the hsn screws into the crab.. hmm what to do

get a new carb or carb body ...thats the only cure i see

 

[Guccii]

haha ty i just got one off ebay hahah jeez had the thing two days and already broke it hhaha nomore messin around

 

[LBSinGTX]

The TRX carb body is definitely fragile. Be careful putting the new one on. I tore a carb body in half once when I tried to pull the air filter off, then I didn't pay attention when assembling the new carb body and trashed that one too. That'll test anything ever learned in anger management class.

 

[StevoRevo]

That has happened to me three times...
One even came stripped already...
And yes all you can do is get a new carb body