XxVASSAGOxX
Gone - bye bye.
whats it mean when a new engine woulnt stay running unless i leave the glow lighter on it... its a TRX3.3 first tank
-
Welcome to RCTalk! 🚀
Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!
- ✓ Friendly & passionate RC enthusiasts
- ✓ RC tips & troubleshooting
- ✓ Buy, sell & trade RC gear
- ✓ Share builds & upgrades
glow problem?
- Thread starter XxVASSAGOxX
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
qaart
Gone - bye bye.
if its a brand new engine that dont like to idle try turning the idle up and if it smokes alot lean it out and no smoke richen it up
XxVASSAGOxX
Gone - bye bye.
- Thread starter
- #3
idle didnt help. think its to rich?
Cupooterluvr
Hardcore RCTalk User
It's either too rich or the glow plug is dead. Try a new plug, and if that doesn't work then lean out the LSN (or HSN... wait for more experienced opinion) 1/8 turn.
XxVASSAGOxX
Gone - bye bye.
- Thread starter
- #5
glow plug is fine.. seems that its to rich.. alot of oil is building up
qaart
Gone - bye bye.
twist the high speed needle in (big needle) 1/4 of a turn if its alot of oil and after that try 1/8th turns
LSN controls fuel monitoring at idle. HSN does as well, but it's more of a side effect than direct impact.
I'd lean out your LSN a bit until you can get it running.
I'd lean out your LSN a bit until you can get it running.
