gear mesh

[Nitro RC Basher]

how exactly do you set the gear mesh. everything i found talks about pitch or something else.




thanx

 

[Candyman]

Easiest way is the paper method. Just take a narrow strip of notebook paper (about as wide as the gear). Place it between the spur and pinion. Push the gears together until they crimp the paper between them. Tighten the engine and turn the gears to remove paper and you're done.

 

[Nitro RC Basher]

how thick of paper? 1 or 2 sheets thick?

 

[Candyman]

Just one sheet is fine.

 

[martrix]

Just one sheet is fine.

and if you find it feels like its locking up, try 2 sheets. I've found 2 layers works for me, but I put decent pressure on the spur when tightening the adjusting screws. Never had a stripped spur.

 

[Scrogg]

2 sheets thickness, or a plastic parts bag works well. The ideal mesh setting is to have as little play between the gears as possible while allowing the gears to spin freely. A good way to check your mesh afterwards is to roll the truck on the floor and listen to the gear noise, it should be relatively quiet.

 

[Nitro RC Basher]

ok well i couldnt set the mesh right on my truck because pon further inspection, i bent the engine mount plate thing so it leaned forward

 

[Gordz]

then take your pate out, replace it or straighten it... a bent engine mount is going to cause you HEAPS of problems later, being stripped spurs, clutch bells, clutch bell rubbing on disc brake, etc etc.


fix it now to save problems later =)

 

[Nitro RC Basher]

i know. it has been this way since a little after i got the truck. never a problem until i took apart the truck to clean it. put it back together and BAM!. huge problem.

BTW i ordered a savage XL TVP conversion kit and new plate braces so that should fix everything.

 

[Gordz]

oh nice, i was going to do that until i realised i've spent $800 in parts on a $700 truck, and i should just buy the XL

 

[Nitro RC Basher]

lol yeah you always spend alot more that yo planned on these things. poop i coulda ought a baja by now