Sold / Found FS traxxas,losi,lunsford,Chargers,Servos

[Z400]

Throwing a parts lot up for sale.

Gathered what i could to make a thread, need this stuff gone, mostly because i do not use it and its taking up needed space.


Servos-

Brand New TowerPro MG995- never been used or mounted
SOLD

JR Racing z8800s, never been used or mounted
$90 shipped

JR Racing DZ8550, lightly used, if i remember correctly
i used this servo for about 5 or 6 tanks.
$70 shipped

JR Racing z9000s, lightly used also, ran this one with the
8550, so it has been used for 5 to 6 tanks.
$80 shipped

Parts-

2 revo pipes,
1 Stock blue pipe in good condition- $10 shipped
1 Big Block pipe, pipe is from new era, rear exhaust for the revo
comes with big tube header. $20 shipped

3 revo bumpers
2 rears- $4 each shipped
1 front- $4 shipped
Revo engine mount, brand new, was pulled off a new 3.3 engine- $7 shipped
Revo Shock Springs-
2 sets of gold, both brand new, 1 nip, $4.50 shipped each
1 set of black, used- $2.50 shipped
1 set of white, brand new- $4.50 shipped
Revo tranny skid $5 shipped
Revo servo guard- $3 shipped
Revo Opti drive- $8 shipped
Revo 2060 micro servo- SOLD
Revo 2.5 tranny cases(2)-$5 shipped each
Revo engine mounts- 2 halvs- $3 each shipped
Revo integy 3 shoe flywheel- $5 shipped
Revo shock parts, 4 caps, 4 collars,3 retainers,2 shafts, 3 shock ends- SOLD
Revo driveshaft yokes, may work with t-maxx and e-maxx- $3 shipped for all 4
Revo- steering servo mounts(2)-$2 shipped
Revo Shock pistons(4) #3's- $4 shipped
Revo shock mounts, 3 rears, 2 fronts. $3 shipped each
Revo servo linkage- SOLD
Revo tranny shafts- $2 shipped for both
Revo tank mounts, 1 stock- $2 shipped, 1 Vantage- $5 shipped
Revo/Maxx Drive shafts, NIP #5450, SOLD
Revo stock tanks, (2 left) SOLD, 2 used, $4 shipped used $6 shipped new
Kyosho ST-R tank, New- $6 shipped
Team Losi 8b Tank,(2) 1 used 1 new, $7 shipped used, $10 shipped new
Lunsford Racing Titanium Revo P3 Pushrods, NIP $28 shipped
Lunsford Racing Revo hinge pins, NIP $19 shipped
Team Losi tank mounts(8B,8T) 3 packs, NIP, $4 shipped each
Prather stick on weights, 6 ounce sections, 12 section bars, 2 bars in one pack. NIP, $12 shipped, 1 complete bar, half of another bar $7 shipped
2 chargers, 1 for 6v receiver packs, 1 for glow igniters. $7 shipped each

Engine-

Traxxas 2.5r Engine, Less then 1 gallon through engine, well taken care of.
comes with everything pictured, $75 shipped

I also have a Spare Piston & Sleeve for this engine, it does not need it, but it is a spare.
$50 shipped

if feedback is needed, PM me


any questions?
PM me or ask here


Thanks for looking



Z

 

[olds97_lss]

Do you have a servo horn for the "Brand New TowerPro MG995- never been used or mounted $20 shipped"?

If not, what horn fits?

Do you have specs on it? If it's what I found at other sites (11kg/c @ .13sec), then I'm interested if a horn can be found or named that will fit it.

 

[Z400]

i have 2 horns for it.

and here are some specs

4.8v 10kg or 140oz
6v 12kg or 169oz
7.2v 14kg or 196oz

i forgot to add, the spline type is Futaba

 

[olds97_lss]

I'll buy it. PM me your PP info and I'll send you the dough.

 

[Z400]

TowerPro Servo SOLD

 

[olds97_lss]

Back at you with $.

Thanks again.

 

[Z400]

price lowered on 2 of the servos

 

[rckid91]

sorry to drag this up from the dead any of this still available??