Z400
Gone - bye bye.
Have got a small assortment of tools I've used to work on R/Cs with in the past.
Havent used this stuff in a couple of months, figured someone else could put it to use.
T-handle hex drivers
All are used, if you strip the tip, just break out the dremel and trim it down some. Sizes- 7/64, 1/8, 9/64, 3mm, 2.5mm, and 5/56
Pair of Lexan Scissors
Assorted phillips and flat head screw drivers
A brand new Hobbico 4 way wrench 5/16, 7/16, 3/8 and 1/2"
And a Diff dunker for stripping diffs of silicone fluids.
I've also got a nearly new set of Integy hex drivers
Sizes- 1/16, 1.5mm, 2.5mm, 3/32, 0.05mm and 5/64"
A nearly new bottle of Z-7 Debonder
(debonding agent for super glues)
And a nearly new Z590 spectrum servo (may be brand new)
Tools and stuff-
The servo-
$30 shipped plus paypal fee for everything
Havent used this stuff in a couple of months, figured someone else could put it to use.
T-handle hex drivers
All are used, if you strip the tip, just break out the dremel and trim it down some. Sizes- 7/64, 1/8, 9/64, 3mm, 2.5mm, and 5/56
Pair of Lexan Scissors
Assorted phillips and flat head screw drivers
A brand new Hobbico 4 way wrench 5/16, 7/16, 3/8 and 1/2"
And a Diff dunker for stripping diffs of silicone fluids.
I've also got a nearly new set of Integy hex drivers
Sizes- 1/16, 1.5mm, 2.5mm, 3/32, 0.05mm and 5/64"
A nearly new bottle of Z-7 Debonder
(debonding agent for super glues)
And a nearly new Z590 spectrum servo (may be brand new)
Tools and stuff-
The servo-
$30 shipped plus paypal fee for everything
