Duratrax Nitro Evader Buggy
Comes with fuel bottle.
two glow ignitors (these are alkaline ignitors, but can have recargeable batteries installed)
transmitter (later 75mhz AM radio, not the 27mhz they first came with)
Rear road tires (little wear)
stock off road tires (quite worn)
Engine is stock, dtx .18 (os engine)
never overheated, broken in using heat cycle method (1/2 gallon through engine)
Has upgraded cooling head, scratched with one bent fin
Roto-start backplate (starting shaft included, so can be started with drill, roto starter not included)
fuel filter installed
OFNA micro fail safe
Extra front a-arms
added a front bumper, I think it's an RC10 bumper.
this is a pretty quick car
starts easy, stays tuned
from tower hobbies:
FEATURES: Chassis: Anodized 7075 T-6 aluminum
Drive: Rear Wheel Drive
Radio: 2 channel Futaba pistol grip AM 75mHz with steering and
throttle trims, adjustable steering rate, servo reversing, charging
jack for optional NiCds (not included)
Engine: .18 (3.0cc) Duratrax pull-start with rotary carburetor and
glow plug
Exhaust: Tuned pipe w/header
Fuel Tank: 75cc (2.53oz) flip top cap
Clutch: Hard anodized slipper type
Transmission: Single speed
Ball Bearings: Complete set, 16 total
Shocks: Four oil-filled, aluminum body with coil-over spring
Main Gear: 56 tooth plastic
Gearbox: Rear, sealed
Differentials: Adjustable ball type
Brakes: Single composite disk
Tires: Rear pin and front ribbed
Wheels: White dish type
Body: Painted polycarbonate with decals applied, see COMMENTS
Suspension: Fully adjustable
Camber Tie Rods: Fully adjustable
Steering Tie Rods:Fully adjustable
Steering: Bell crank type
Servo Saver: Included
$110 shipped to US only, sorry cannot ship outside of US.
forgot to add: 5% goes to rcnt
Comes with fuel bottle.
two glow ignitors (these are alkaline ignitors, but can have recargeable batteries installed)
transmitter (later 75mhz AM radio, not the 27mhz they first came with)
Rear road tires (little wear)
stock off road tires (quite worn)
Engine is stock, dtx .18 (os engine)
never overheated, broken in using heat cycle method (1/2 gallon through engine)
Has upgraded cooling head, scratched with one bent fin
Roto-start backplate (starting shaft included, so can be started with drill, roto starter not included)
fuel filter installed
OFNA micro fail safe
Extra front a-arms
added a front bumper, I think it's an RC10 bumper.
this is a pretty quick car
starts easy, stays tuned
from tower hobbies:
FEATURES: Chassis: Anodized 7075 T-6 aluminum
Drive: Rear Wheel Drive
Radio: 2 channel Futaba pistol grip AM 75mHz with steering and
throttle trims, adjustable steering rate, servo reversing, charging
jack for optional NiCds (not included)
Engine: .18 (3.0cc) Duratrax pull-start with rotary carburetor and
glow plug
Exhaust: Tuned pipe w/header
Fuel Tank: 75cc (2.53oz) flip top cap
Clutch: Hard anodized slipper type
Transmission: Single speed
Ball Bearings: Complete set, 16 total
Shocks: Four oil-filled, aluminum body with coil-over spring
Main Gear: 56 tooth plastic
Gearbox: Rear, sealed
Differentials: Adjustable ball type
Brakes: Single composite disk
Tires: Rear pin and front ribbed
Wheels: White dish type
Body: Painted polycarbonate with decals applied, see COMMENTS
Suspension: Fully adjustable
Camber Tie Rods: Fully adjustable
Steering Tie Rods:Fully adjustable
Steering: Bell crank type
Servo Saver: Included
$110 shipped to US only, sorry cannot ship outside of US.
forgot to add: 5% goes to rcnt
Last edited:
