• Welcome to RCTalk! 🚀

    Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!

    • ✓ Friendly & passionate RC enthusiasts
    • ✓ RC tips & troubleshooting
    • ✓ Buy, sell & trade RC gear
    • ✓ Share builds & upgrades

Flywheel Differences

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
Yea, when you acc the linkage moves in (toward the carb), and when you brake you know. I'm looking for a body now to finish the restoration. You guys wouldnt know anyone with an old Losi body or another stadium truck body? Thanks Chris
 
I would imagine that a XXXNT body should fit. Then again, I could be wrong. Perhaps take it to the local hobby shop and dry-fit a few?
 
I was hoping to get an orig GTX,NXT,LXT body to finish the resto. When i did the XXXNT rear swap on my NXT i had to change where it mounts on the back from 1 center hole, to 2 outer ones. The front I think is the same, Should put my NXT body onto my XXXNT and see where the mount holes line up.
 
Alright i finally finished my restoration. I dont have the body yet but I did order it. When I get it and paint it up I will post it. Here are the pic of the truck.

TeamLosiGTXRF2.gif

TeamLosiGTXLF2.gif

TeamLosiGTXRR.gif

TeamLosiGTXLR.gif
 
Thanks for all the help heartbreak. You always seen to know how to solve my problems. Thanks
 
No problem amigo. I just spend a lot of time reading the forums... Theres' tons of good info here.
 
I got the 2 bodies today for the GTX, I havent decided if I'm going to re-paint or just leave them as is. What do you guys think?
 
Last edited:
I'd say the top pictured body is a much better fit. Do you know what model the body is for?
 
Both bodys are off a XXXT I think. Both bodys are the same, I just had them laid on top of the truck so none fit right yet.
 

Similar threads

C
1/10 differential
Replies
1
Views
158
tudordewolf
tudordewolf

RC Builds

Back
Top