Finally a good outing!

[JSY0829]

Here's how it's been lately with my Tmaxx(stock 2.5 mill). Run a few minutes and adjust idle...stall. Start and run a few times up and down the road and stall. Adjust LSN and run a few minutes and stall. Temp would get too hot and adjust HSN...then idle would be too high. After a gallon if this, I yanked the mill out and put in an OS .18tm which I purchased from kurt_02f150.

:OMG: <<that was my reaction after I started her up. Temps are steady at 265 and I've ran 5 tanks today and I havn't had to touch a thing. Wheelies on command but I will gear it a little higher to take care of that. I wish I would have done the swap sooner.

 

[nitro_freak_123]

sounds good mate

 

[kurt_02f150]

Glad that tune is working for you. It can probably be tweaked for even more power. I couldn't keep my max in one piece long enough to get a final tune on it.


Nice mill huh?

 

[olds97_lss]

I felt the same way when I put one into my revo...