Fantom .27

[Mudbug]

This is just to give everyone a lil heads up. Do not use the hpi ribbed pipe with the fantom .27. i used it and blew 1 motor and almost another because no matter how much you open the hsn you can not get the temps under 250. i put the metal hpi dual camber pipe on it an dthe temps dropped down to 210 and alot more power.

 

[jon2]

whoa did you check if your pipe has anything stuck in it that could obstruct its flow? Sounds a bit odd.

 

[Plaidfish]

yeah I use the ribbed pipe on my Fantom and it's bad ass.....I had to set my controller expo to act as slow as possible on the bottom so I could get the wheels to bite....my temps rarely go over 250 on it as well...only if I'm beating the piss out of it.....sounds like your PIPE was defective dude....

 

[.21Rc10GT]

Or it had something stuck in it, as stated above.