XxVASSAGOxX
Gone - bye bye.
does anyone no the factory lsn and hsn settings on a os max.18tm?
-
Welcome to RCTalk! 🚀
Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!
- ✓ Friendly & passionate RC enthusiasts
- ✓ RC tips & troubleshooting
- ✓ Buy, sell & trade RC gear
- ✓ Share builds & upgrades
factory settings?
- Thread starter XxVASSAGOxX
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
charliejp
Hardcore RCTalk User
I believe that both needles are to be flush on that mill.
XxVASSAGOxX
Gone - bye bye.
- Thread starter
- #3
the hsn flush? i dont understand, its the exact same looking set up as the trx3.3 i made the lsn flush with the inner ring on the slide, but i need to no how many turns out the hsn should be when its factory
charliejp
Hardcore RCTalk User
Sorry about that. I was referring to the 18 cvr and on the one I had the hsn is inside a metal sleeve. If you set it flush with the sleeve, that's factory. Hang in, someone will chime in with more info.
XxVASSAGOxX
Gone - bye bye.
- Thread starter
- #5
yea i just can't find much tuneing info on this .18TM but ill tell yea the topspeed is insane on it