Sold / Found f/s: Futaba s9450 Dual Bearing Digital servo

[arawak420]

$55 shipped lower 48 states 2-3 day priority. i accept paypal.

hardly used in great condition with rubber groomets.

the s9450 has
81/.18 oz. torque at 4.8v
111/.10 oz. at 6.0v. this is a high-speed servo. dual bearing digital barely used.

if you have other brands of high torque servos i may be interested in them as well as long as they are high torque. send specs on the servo you have if you would like to trade, must be in the good condition of the servo I'm trading you.

Dimensions 40.5×20×37.5mm
Weight 55g
Operating Speed 0.10sec/60° (6.0V)
Output torque 8.0kg·cm

 

[Plaidfish]

Hitec HS-5645MG High-Torque 2BB MG Servo S/JR/Z

SPECS: Speed: 0.23 sec/60 degrees at 4.8V
Speed: 0.18 sec/60 degrees at 6.0V
Torque: 143.03 oz/in at 4.8V
Torque: 164.2 oz/in at 6V
Length: 1.59" (40.6mm)
Width: 0.77" (19.8mm)
Height: 1.48" (37.8mm)
Weight: 2.11oz (60g)
Used about 3/4 gallon in a 1/8 buggy....works perfect...

 

[arawak420]

do you have the aluminum servo horn that comes with that servo? where are you located? I'm in L.A.

I'm using the other s9450 i have for the throttle/brake. this servo turns the wheels on my savage sitting still on the carpet, but I'm not sure how effective the servo is going to be with some big joes on it. want more torque and the s9450 is high speed. used in street race cars.

 

[Plaidfish]

I'll look and see if I still have it.....they are cheap to buy...like 4 bucks at LHS.....
I want yours for throttle/brake on my buggy....the hitech is a little slow.....I tried faster servos for a while but I sold em w/ an RC....the hitech I have doesn't respond quick enough for air time control.......

 

[Plaidfish]

are you interested?