Leshill
RC Newbie
- Messages
- 3
- Reaction score
- 0
Hello, having once again broken the pull cord on the EB4 I set about installing a roto start instead. Order the module and fitted it but found that it does not fit 100% perfect. It’s about 2mm proud of being flush with the engineer alloy. If I tighten up all four screws it fits but won’t turn.
If I reverse the bearing and then fit the unit it’s all good but of course needs to spin clockwise instead of the normal anti clockwise direction to start the engine.
Now of course I can use a slow battery drill to start it but I’m not sure if this could cause other issues.
The roto start module If 2mm thicker would have worked fine.
Anybody got any ideas?
If I reverse the bearing and then fit the unit it’s all good but of course needs to spin clockwise instead of the normal anti clockwise direction to start the engine.
Now of course I can use a slow battery drill to start it but I’m not sure if this could cause other issues.
The roto start module If 2mm thicker would have worked fine.
Anybody got any ideas?
Attachments
-
09823D89-D51A-4B85-8FEC-7644815C79C4.jpeg351.1 KB · Views: 23
-
75CF59C7-8BFB-4717-9E8F-78E51D93DE1C.jpeg337.1 KB · Views: 25
-
3D999A2F-9BD2-45E2-9103-ECBB4C0F515A.jpeg229.4 KB · Views: 26
-
E38DF81E-7A69-4B5B-8158-F8AB7433F017.jpeg238.9 KB · Views: 24
-
3A6DC075-1E6C-4812-8286-57CDCB450E86.jpeg250.4 KB · Views: 28