Early Traxxas transmission

[Coreyg1991]

I'm trying to take apart my transmission on my Traxxas stampede 2WD it's a gen 1 or so and I can't get there and have can't get the axles to come apart to take the trans case apart. I took to small Allen head screws off each axle how do I get them off?

 

[tntpoof]

a small screwdriver slide behind that white nuckle

 

[WickedFog]

They are likely just corroded on there. A little elbo grease may be required.

 

[pug]

It should just be able to be pulled right off, try using a flathead screwdriver if you can't get it off.

 

[Coreyg1991]

My camera is horrible but there is a phillips head screw in the middle of that white piece that doesn't need to come out? Ijust don't wanna break it it's on there pretty good

 

[tntpoof]

yes remove black drive shaft then remove phillips head screw..plastic doesn't corrode to steel.

yes remove black drive shaft then remove phillips head screw..plastic doesn't corrode to steel.

 

[Chubaka]

They are likely just corroded on there. A little elbo grease may be required.

Take off the black driveshaft from the white yoke. The white yoke has one or two vertical grub screws, and a countersunk horrizontal screw.

You can replace with the single vertical grub screw.

 

[WickedFog]

yes remove black drive shaft then remove phillips head screw..plastic doesn't corrode to steel.

I couldn't tell in the blurry pic that it was plastic

But that seems strange that it has a pin grub and a face screw holding that on.

 

[Coreyg1991]

I'm trying to take apart my transmission on my Traxxas stampede 2WD it's a gen 1 or so and I can't get there and have can't get the axles to come apart to take the trans case apart. I took to small Allen head screws off each axle how do I get them off?

I figured it out thank you forum is always very informative

 

[tntpoof]

watch out 4 rusty plastic its a witch lol(classic)