blckrevo33
RCTalk Talkaholic
the problem is that the pos and ground keep vibrating off. i pinch the clip to tighten it but it doesn't last. i was wondering if there are any tricks or mods to the clips so they stay on better any suggestions ? thanks.
-
Welcome to RCTalk! 🚀
Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!
- ✓ Friendly & passionate RC enthusiasts
- ✓ RC tips & troubleshooting
- ✓ Buy, sell & trade RC gear
- ✓ Share builds & upgrades
E-Z start wiring issue
- Thread starter blckrevo33
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
GrudgE
RCTalk Addict
Yep swap to pull start and sell ez-start motor, wand, battery, and charger. Or if your attached to it you can try putting new connectors on the wires sounds like they have had there time.
brad55102
RCTalk Addict
get a new one,
i've had this same problem, you can try and rig it if you want but the fact remains, you need a new one.
There only like $4
i've had this same problem, you can try and rig it if you want but the fact remains, you need a new one.
There only like $4
i ve found that an alligator clip on the blue glow plug wire is a good trick because the stupid coil stretches out really fast and with an alligator clip it holds and doesn't come off but when you need to change ur glow plug just stick ur needlenose pliers down and release it. . .
blckrevo33
RCTalk Talkaholic
- Thread starter
- #5
ok thanks guys i had a new wiring harness anyway so i put that on and all better for now. thanks