Rangerrico32
RC Newbie
Hey guys,
I have a emaxx brushless, with the mamba, and I run two 3s 11.1v traxxas lipos on it. I was snapping rear drive shafts left and right, so I went with traxxas aluminum ones. I dont think this is related but after I installed them, now when I punch the throttle the spur gear and the pinion gear make a grinding noise, if I acclerate slowly it doesn't do it, but when revved quickly it does. Is the problem that they are not aligned correctly? thanks
I have a emaxx brushless, with the mamba, and I run two 3s 11.1v traxxas lipos on it. I was snapping rear drive shafts left and right, so I went with traxxas aluminum ones. I dont think this is related but after I installed them, now when I punch the throttle the spur gear and the pinion gear make a grinding noise, if I acclerate slowly it doesn't do it, but when revved quickly it does. Is the problem that they are not aligned correctly? thanks
Last edited by a moderator:
