-
Welcome to RCTalk! 🚀
Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!
- ✓ Friendly & passionate RC enthusiasts
- ✓ RC tips & troubleshooting
- ✓ Buy, sell & trade RC gear
- ✓ Share builds & upgrades
drop in .21 engine
- Thread starter rccars411
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
Z400
Gone - bye bye.
how do you like it?!
scoobydoo2u
RCTalk Addict
Based on the "1/10 scale is dead" and the "traxxas is red cat racing quality" comments I don't think it is his.. Though i may be wrong.. wouldn't be the first time.
five21racing
RCTalk Basher
- Messages
- 55
- Reaction score
- 0
- Points
- 0
- RC Driving Style
what's with the 2 zip ties on the rear shocks?
- Thread starter
- #5
his springs could be too short, so therefore he is using the zipties.
A: i dont run OS engines. I strictly run STS mills.
B: I will never run a traxxas product (can't race one according to my contract lol)... although, the revo is the only traxxas i'd consider... but its got a gearbox instead of a center diff
C: there isn't enough 1/10 scale action here to even consider getting a small monster truck.
A: i dont run OS engines. I strictly run STS mills.
B: I will never run a traxxas product (can't race one according to my contract lol)... although, the revo is the only traxxas i'd consider... but its got a gearbox instead of a center diff
C: there isn't enough 1/10 scale action here to even consider getting a small monster truck.
Last edited:
Where can you buy that engine? The 18TM was pretty nuts...
- Thread starter
- #8
i remember first generation of sirio .23's, they sent rods thru the case.
Olds, as far as i know, its not even available yet. I have no clue as to when its supposed to be available. With GPMD controlling prices on OS engines, it isn't going to be cheap lol.
Olds, as far as i know, its not even available yet. I have no clue as to when its supposed to be available. With GPMD controlling prices on OS engines, it isn't going to be cheap lol.
I have an XTM 24.7 in mine and it's pretty much undrivable on a track. I took it to a MX track yesterday and it was like driving a snake that wheelies... I had to be so easy on the gas that I couldn't get it to hit second gear. If I wasn't easy, it would either spin out or do a wheelie off the line. When/if it did hit second, it would pull a wheelie and I'd lose it. I'm considering putting my 18TM back in it... I just need to get the RS4 header so I can still run a side pipe.
