• Welcome to RCTalk! 🚀

    Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!

    • Friendly & passionate RC enthusiasts
    • RC tips & troubleshooting
    • Buy, sell & trade RC gear
    • Share builds & upgrades

Don't let your friends drive your rc.

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
NCNitro said:
LMFAO! Well you put the controller in my hand, so really who's fault was it? This is actually a bit of a lie, I did not scrape the body as you wanted to tune it with the lid off if you remember correctly. That was done as you went flying down the straight away end over end. And don't forget the new defective shock towers too, they are too soft :whistle: I was just showing you how the bottom end was, that is what you asked, lol. And after being oh so careful with it while I was breaking it in. Oh that sound, I can still hear it clearly, that metal scraping across the asphalt. :8-0:



lol this could get good,comon lady's :boxing:
 
NCNitro said:
LMFAO! Well you put the controller in my hand, so really who's fault was it? This is actually a bit of a lie, I did not scrape the body as you wanted to tune it with the lid off if you remember correctly. That was done as you went flying down the straight away end over end. And don't forget the new defective shock towers too, they are too soft :whistle: I was just showing you how the bottom end was, that is what you asked, lol. And after being oh so careful with it while I was breaking it in. Oh that sound, I can still hear it clearly, that metal scraping across the asphalt. :8-0:

I remember it like it was yesterday... The shower of sparks as my shiny rollbar scraped the tar off the parking lot.... lol
Your right, My lid was off at the time... Lucky me
Instead of a scraped lid, I got a scarred up roll bar, shorter towers & an amateur deannodizing on my cooling head...
 
Back
Top