• Welcome to RCTalk! 🚀

    Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!

    • ✓ Friendly & passionate RC enthusiasts
    • ✓ RC tips & troubleshooting
    • ✓ Buy, sell & trade RC gear
    • ✓ Share builds & upgrades

diffs

  • Thread starter Thread starter tannera
  • Start date Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
T

tannera

Guest
i just done the 4 spider diff mod but when i push the truck it dosen't roll like it did before i done the diffs it's like the breaks are on i bit but there not.
and it jams up a bit when lets off and jams up again i have put 7000w/t in both is this normal?
 
Putting oil in the diffs and the 4-spider mod shouldn't make it roll any different, at least not in a straight line.

What else did you replace? Diff cases? Bearings? Diff cups? Diff cup gaskets?

Are you certain it isn't the brakes dragging? Is the gear mesh between the CB/spur the same (did you remove the engine)? Did you grease the ring/pinion gears in the diff?
 
i found out what is was i still had to mesh my gears and that's what was stoping it. also i had put to much oil in the front diff.
 

RC Builds

Back
Top