• Welcome to RCTalk! 🚀

    Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!

    • ✓ Friendly & passionate RC enthusiasts
    • ✓ RC tips & troubleshooting
    • ✓ Buy, sell & trade RC gear
    • ✓ Share builds & upgrades

Clutch engagement

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
A

agenttnk

RCTalk Racer
Messages
116
Reaction score
0
Points
0
RC Driving Style
Hey, i have the .25ss engine with the 3 cluthch shoe and RB steel clutch bell and spur gear and i was wondering if theres something i could put on the shoes to give them more grip like powder or something.. cause i can do little wheelies but it sounds like the clutch is slipping to much and the slipper cluthch is 1/2 turn from tight
 
You could try putting a dab or two of CA glue on each pad ad let it dry i remeber hearing or reading of people doing that on larger scale rc's
 
The other recommendation I would make would be to scuff sand the contact surface of the shoes very slightly. Just enough to rough them up a bit. You could also do the same to the interior surface of the clutch bell. This would create a little more friction and allow for a bit more grab.
 
so the aluminum is better than the stock plastic? i want it so that it would take off right away like the racing clutch for my rs4 3
 

RC Builds

Back
Top