• Welcome to RCTalk! 🚀

    Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!

    • ✓ Friendly & passionate RC enthusiasts
    • ✓ RC tips & troubleshooting
    • ✓ Buy, sell & trade RC gear
    • ✓ Share builds & upgrades

Carb Issues

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
T

TMaximizer

RCTalk Qualifier
Messages
151
Reaction score
0
Points
0
RC Driving Style
  1. Bashing
It seems as if my low speed needle aint doin anything when i try to adjust it. Anyways, is there a proper way to clean it?

PS. What the hell are the stock adjustments again
 
Last edited by a moderator:
It should be set to 4 turns HSN and 2 turns LSN for factory settings and to clean the carb you can remove it from the engine,remove the needles from the carb and clean them with denatured alchohol..also soak the carb body in the alchohol and make sure the carb needles have o-rings...its best to re-install the carb needles and the carb with new o-rings..

You may have an airleak at the ez-start backplate , carb needles/ base or have a glowplug issue...if you have a 3.3 an OS8 plug works the best in mine..
 
Last edited:
thanks for all you help everyone, I'm gonna test some theories
 

RC Builds

Back
Top