carb help!

[kxmonster219]

i dont know where mmy carb should be i think this is right can somone tell me?

thank you

if you open in new tab you can zoom in it is a higher resalotion than is shown there

 

[Snook Man]

Will not open in new tab for me...

Generally you want a 1mm or, preferably less idle gap.

 

[Non Crimen]

Way to small of a picture. Try taking a different one, kinda looks like it's wide open. Like snook said; 1mm is ideal.


Sent from my *PiMP Boy-3000*

---------- Post added at 10:13 AM ---------- Previous post was at 10:13 AM ----------

Can't open in new page as well.


Sent from my *PiMP Boy-3000*

 

[kxmonster219]

how do i measure 1mm

 

[Non Crimen]

A credit card is about 1mm thick


Sent from my *PiMP Boy-3000*

 

[kxmonster219]

ok thanks

 

[Nitro4910]

A number 60 or 61 sized drill bit, use the smooth shank of it, both are just slightly off 1mm.
Either will work.

If you decide you want to try a smaller idle gap use the # drill bit chart below to pick the size bit needed.
http://bobmay.astronomy.net/misc/drillchart.htm

 

[moe7404]

harbor fright has a caliper that is 4" long. about $20. it does inch and metric. but check it before you take it home. you can set it on metric and switch it over to compair the two.