Can I use lock-tite on a servo?

[T-maxxJared]

The screw that goes through the center of the servo saver into the output shaft on my steering servo keeps on backing out when I drive the truck, and this lets the servo saver come just loose enough to slip and cause the wheels of the truck to not steer left or right, but get stuck in just 1 position. Can I use lock-tite on this screw or does anybody have a better solution? The servo is a hitec 645MG and the saver is made by kimbrough.

 

[wannarunem]

yeah i dont think it would hurt anything...use half a drop of green locktite.

 

[svenz]

Yeah I use lock-tite on my servos, had no problems.

 

[maxxmasher8]

i also use loctite on my servos and it works well.

tyler