Cable came off of motor.

[chelseafc385]

I am in the middle of rebuilding my XTM Rage, because i am selling it and a few parts needed to be replaced. I've almost finished rebuilding it, but i just realised that one of the cables has come off (the black one). I'm not sure what I'm meant to do. Do i just strip back the wire a little bit so that there is a bit of cable and then just re-solder it, or do i do something else? The only thing is, I havnt had that much practice with soldering.

Here is a picture of the cable that has came out:

I will be posting the Re-build in the members project section. If you like it, i will accept offers!

Thanks for the help!

 

[beason]

yea jsut strip it back a little and solder it back on. shouldnt be that hard. if you tin the wire a little it will help it to stick better.

 

[chelseafc385]

Thanks Beason! I thought that i would have to do that, but i wanted to be sure before i started.

Well the cable is back on and it works fine! thanks again Beason.