• Welcome to RCTalk! 🚀

    Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!

    • ✓ Friendly & passionate RC enthusiasts
    • ✓ RC tips & troubleshooting
    • ✓ Buy, sell & trade RC gear
    • ✓ Share builds & upgrades

Blacked the rims out on the Maxx today

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
Lol ok. I'll go digging in my basement cuz I know I used a can of matte black spray paint to paint this shelf for my mom. It's still gotta be down there... Somewhere... Hopefully. It's been like 2 years lol
 
HA HA you all sure are somthing! I got my RD logics pipe in today wow its loud and abit faster. Now I have to take it the the LHS tommorow I burned out my 72 tooth spur gear. I can't seem to line the motor up right with the grear, and I dont want to keep burning up my spurs.

If you all were closer to me or the opposite we could have our club ! LMAO!!!
 
rims.gif


they arent black but imo they still look good!
 
Bushwaker said:
HA HA you all sure are somthing! I got my RD logics pipe in today wow its loud and abit faster. Now I have to take it the the LHS tommorow I burned out my 72 tooth spur gear. I can't seem to line the motor up right with the grear, and I dont want to keep burning up my spurs.

If you all were closer to me or the opposite we could have our club ! LMAO!!!
Click to expand...

A good way to see of your meshing is right is to take a thin strip of paper and run it between your clutch bell and your spur gear. The paper should have even ridges when you pull it out the other side. If it doest then you need to adjust your meshing to compensate and check it again
 

RC Builds

Back
Top