best engine mount

[srad750c]

getting a picco p3 .28, what is the best mount for this engine. i would like to use my easy start if possible, my next option would be the ofna shaft starter setup and finally a rd logics starter box setup. any ideas out there? :\

 

[olds97_lss]

The only one I know of that will make it fit is a new era leaning BB mount. Will require either the NE BB header and a new pipe or some type of a side pipe that you mount up.

This is the mount: http://www.neweramodels.com/item.cgi?part_id=2553

IMHO, it's way too much engine for a revo. I had a tame BB (XTM 24.7) in mine a few years back and all it was good for was wheelies and bending the engine bay when landing jumps. I switched back to a OS18TM shortly after installing the BB.

 

[hamz9561]

The Picco .26 Maxx is a direct bolt in for the Revo. It is more than enough motor to pull the wheels up on command. The good news that it won't eat drive line parts like its bigger brother.

 

[revo_rob_1984]

The Picco .26 Maxx is a direct bolt in for the Revo. It is more than enough motor to pull the wheels up on command. The good news that it won't eat drive line parts like its bigger brother.

I totally agree with Hamz9561, i run a picco .26 maxx and i wouldn't use anything else, its more than enough power to pull the wheels up when you want it to and if you just want it to take off like a rocket it will do that too. .. the .28 is just too much for a revo,