Sold / Found Aluminum case......

[Nitrobuzzard]

Looking for an aluminum case for the T-Rex electric heli.

Here's the dimensions;

698 x 203 x 284(mm)

Need for it to have the "tear away" foam........here's a pic of what I'm looking for.....

Found them E-bay for close to a $100....not looking to spend that kind of bread to get one.........thanks

-Nitro

 

[HeartBreak]

About the closest I've seen like that is Home Depot - but I never measured the dimensions. I'm sure they might have somethin like that.

 

[FastEddy]

check Harbor freight.

 

[Nitrobuzzard]

Thanks guys but its a no go at both places.........They have some nice cases but they are too small.......I need a minimum of 26 x 11 x 6 (inches) If they have them that big I didn't find them........

-Nitro

 

[FastEddy]

Make a post here.
http://www.runryder.com/

 

[FastEddy]

I also found this.
Its below my cost new. Dont know what they want for shipping.
http://www.rcandme.net/catalog/prod...d=775&osCsid=e019a362f43d7f783efda352b4217acd

 

[sweetdiesel]

Here is one like Eddy found for 68 shipped.

http://cgi.ebay.com/Align-T-REX-450...DVWQQrdZ1QQcmdZViewItem?hash=item300063013813

 

[Nitrobuzzard]

Ed - thanks bud, I'll look into it. Still more then what I was wanting to spend, was hoping to find one for around 40-50 shipped...LOL.....yea I'm a tightwad.......


SD - By the time I got there, it had already sold....better than what I had been finding but still more.


It doesn't have to have the "Align" on it, actually would prefer it without as I don't have a Rex, I have the MX400 Pro. I know when I bought my transmitter case, the JR cases were selling for like 60 bux, I went to Lowe's and picked up one that was identical for 20. Given it didn't have the big "JR" stamped on it but......nothing a decal wouldn't take care of...LOL


Thanks again and I'm still looking.......like usual