#4995 primary gear revo

[motorcycleman1]

i keep striping my primary gear in revo transsion #4995 . I'm thinking my slipper clutch is too tight. dose anyone know if someone makes a steel one

 

[chickenman242]

Try loosening the slipper a bit but also check you are putting shims in the right place as that can help the gears mesh a bit better
What engine??
What wheels/tires??

 

[olds97_lss]

RRP sells full steel internals for the revo trans. I have all steel in my BB revo. I'll probably keep the small block revo I have coming as plastic unless I start busting gears with a 3.3 in it.

This is what I h ave in my big block:
Standard ratio RRP Steel

I don't see just the primary output gears for sale. Unless those are the gears the FOC replaces.

You can find all of them here: http://www.robinsonracing.com/catalog/catalog.html#

 

[Revo'D]

If you fit the steel rrr top shaft wide ratio only would that help?

Rcboyz have them pretty cheap I thought I would just need those but now think I mayaswel leave it than just have top shaft. If I wanted to get the full steel foc what other gears would I need?


http://www.ebay.co.uk/itm/350840385637?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1423.l2649

They seem very cheap.

 

[Snook Man]

You can't just change the top shaft ratio, you have to change the primary 2nd gear to match the top shaft ratio.

For full steel you would need all the gears. Input/primary and output.

 

[motorcycleman1]

stock engine and tires . yes i will check spacers. also loosen sliper. o and its my tmaxx not my revo sorry

---------- Post added at 1:04 AM ---------- Previous post was at 12:57 AM ----------

Try loosening the slipper a bit but also check you are putting shims in the right place as that can help the gears mesh a bit better
What engine??
What wheels/tires??

i bet it is the shims . all stock with wide ratio 2nd

 

[chickenman242]

download the exploded veiw from the traxxas site,helps every time.