• Welcome to RCTalk! 🚀

    Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!

    • ✓ Friendly & passionate RC enthusiasts
    • ✓ RC tips & troubleshooting
    • ✓ Buy, sell & trade RC gear
    • ✓ Share builds & upgrades

3.3 center driveshaft with 2.5 trans

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
Y

yz250rider

RCTalk Member
Messages
31
Reaction score
0
Points
0
Location
cape cod, ma
RC Driving Style
  1. Bashing
will the center driveshafts from the t maxx 3.3 fit my old pro.15 maxx? i just ordered all 6 driveshafts from a 4908 model along with the a arms and turnbuckles off ebay but I'm not sure if the center driveshafts will fit.
 
No I don't think so. The 3.3 center driveshafts are longer than the ones for the pro.15 due to the fact that the 4908 has an extended chassis, 30mm longer than the old one. The A arms should bolt on no problem, however I'm not sure if the axle carriers or diffs will work with the 3.3 axle shafts you may have to upgrade those as well I saw several sets of both on ebay,( I love ebay!), while you're into it you might as well pickup some 4908 bulkheads thay are a lot stronger than the pro.15 and will fit right on the old chassis.
 
i know the axle carriers and diffs will work with the axles. i heard you can cut the center driveshafts to fit lengthwise but where they fit on the tranny its different. i dont have much $$ to spend on it because i race dirtbikes and that is expensive. so i wont be replacing the bulks or anything else if its not necessary.
 
Last edited:
You might search ebay and see if there isn't a set. If not I think the 2.5 center shafts will work
 

RC Builds

Back
Top