- Thread starter
- #21
Nice work! it's been a while since i've seen any one else with reversed rear axles. Interesting choice of Hubs with 608z skateboard bearings . . . . not seen those either.
The Hubs are my design...=devil
-
Welcome to RCTalk! 🚀
Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!
- ✓ Friendly & passionate RC enthusiasts
- ✓ RC tips & troubleshooting
- ✓ Buy, sell & trade RC gear
- ✓ Share builds & upgrades
2.2 Pimp Cane Destroyer
- Thread starter run2jeepn
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
The Hubs are my design...=devil
Clodworx
RC Newbie
Real Cool! How are the TTR rear drive shafts holding up without any lock-out? :England:
- Thread starter
- #23
Haven't broke on yet.
Clodworx
RC Newbie
i seriously doubt that at 8mm they'll ever break, just wondered if the lack of support might have caused them to bend . . . .
