Yokomo wheels on ntc3

[invaderzim__]

Yokomo is in asia: metric system. Team associated in america: old english system! The wheel hole is too small on the yokomo wheels i got. THe hex fit right. Should i drill the hole bigger? OR how?

 

[espeng]

What kind of wheels was that? The tires I use are from Hong Kong, and they fit perfect.. The hole is a little bit tight, but that's not a bad thing..

 

[invaderzim__]

o, i fixed the wheels by drilling the hole a little bit bigger. and the yokomo wheels i used were; TW-1012-2 0mm offset presision dish wheels.

 

[Jarc]

it wont hurt to make the hole the correct size for the axle. The hole is just there to KEEP the wheel on the axle. The real backbone is the HEX....


At this point you can take a body reamer and lightly open the hole untill it fits on without a prob. Just dont take so much that the nut wont keep the wheel on.

 

[invaderzim__]

Ya, i know. i dident use a reamer though. I used a drill and found what bit is the same size as the hole on the othere wheels and drilled. i went to go drive today and it worked fine.:w00t: