Sold / Found WTB, Roto Start for RC10GT.

[Tweak]

I am looking for a good condition, complete Roto Start or Starter Box for an Associated RC10GT truck. I will donate an extra ten bucks to RCNT when purchase is complete. Thank You all for looking.

P.s, I know, it sounds dumb, but I don't want to post a WTB ad without adding something for RCNT. I did not know if I should go by percentage or what.

 

[bustedgears]

I'd keep my eyes on a starterbox.

have you considered a tigerdrive?

 

[Tweak]

Don't know what that is... <~~~ stupid n00b

 

[beason]

its like a rotostart
but uses a notmal drill instead of a rotstart wand..
with a small block motor you should be ok with a pull start.. once you get it tuned

http://www.rchobbies.org/sullivan-tigerdrive.htm

 

[Tweak]

Well, i can't even get it to start up now, Don't know why but I can't. The gas seemed like it wasn't getting to the carb, I ritchend it. Motor flooded, I pulled the plug, drained it and tuned, tried again. Got a few pulls, flooded it. Dumped the gas outta the exhaust pipe and tried again. Got some good pulls but still nothing. Chacked like three diffrent plugs, all were good. Still can't do it. I jsut need to get something to ease my arm muscles while I am trouble shooting the damn thing...

 

[1500valk]

alrighty, this might work for you, tweak. I have used one on my Duratrax Nitro Evader. Basically, you won't need a roto start, just a drill. but.... it only works on vehicles with sideways mounted engines like the rc10. Very slick, very high quality.
you just remove your pull start but leave the shaft on the engine (the shaft that the pull start one-way bearing attaches to). works like a charm.

http://www2.towerhobbies.com/cgi-bin/wti0001p?&I=LXSG87&P=ML

or, PM me and I can tell you how to make one for a lot less!

 

[Tweak]

I have seen these around, never knew what they were for, I assumed they eliminated any excess slack in the drivetrain lol. Thanks man, I will PM you. Thread closed