Sold / Found WTB .12-.15 engine, Exhaust for MST1

[hudler]

Hi I am looking for some inexpensive parts for a Mugen MST1 kit I am assembling...Need a good .12-.15 non pull, threaded crank, rear exhaust,rotory carb (prefered) engine and pipe/manifold for same. PM if you have something I could use. Thanks!!

 

[RatzoRC]

I have a near new Fantom .12 (might be a .15) I'll have to look.

Only had 2 break in tanks.
I bought it for my son who never got into RC

 

[hudler]

Check back with a price and engine specs, I could use either side or rear exhaust, but need standard threaded shaft crank.....thanks!

 

[RatzoRC]

Check back with a price and engine specs, I could use either side or rear exhaust, but need standard threaded shaft crank.....thanks!

It is a .12 rear exhaust, threaded shaft.
I made a mistake when I said it was ran for 2 break in tanks. It was broken in (4 tanks) then driven for break in for 2 tanks. (I wanted to be clear on that)

It also has a THS racing pipe (also 6 tanks) with no dents or dings.

I'm not sure of the clutch, but I'll leave the clutch, flywheel and clutch bell on the engine.

LMK if you want the engine alone, or both.

I'll post up a few pics while you think about it.

 

[hudler]

Nice engine, I would be interested in all of it, I don't think the manifold will work in the mst, but the pipe should.....clutch, no clutch doesn't matter to me.PM me a price for the engine and pipe when you get a chance, thanks!

 

[RatzoRC]

You have a PM

 

[Pedester]

If he doesn't want the manifold, and it fits xxxnt, I may be interested.
(Manifold only)