Sold / Found WTB: 1/8 Header

[Z400]

Looking for a 1/8 Header


need one as close to this one-

Looking for one that is in good shape

prefer no dents, but i can fix those if there are any

paypal ready


pm me or reply here

 

[Plaidfish]

I've got a few pipes (w/ headers) for sale.....20 bucks for the OFNA .53 pipe.....it's got 2 minor dents......what mill is this for? I have some other pipes but they are a little more cash since they were 135 new....

 

[Z400]

Its for a marine GoTech .25

 

[Plaidfish]

I've got an HPI ribbed pipe that has that type of Header....the pipe is like new, I don't want to part them out but 20 shipped for pipe and header?

 

[Z400]

Its for a marine GoTech .25

I've got an HPI ribbed pipe that has that type of Header....the pipe is like new, I don't want to part them out but 20 shipped for pipe and header?

Its for a marine engine, which means its for a boat

i have no use for a HPI savage pipe or header


The HPI header doesn't push the pipe far enough out to the side of the engine.

I'm trying to not have to cut up a header and extend it with a coupler so i can add my 2 water cooling coils onto the un cut header.


i have the same header i pictured in my first post, but i hacked it up before i had my exhaust set up set in stone and pretty much finished(I'm building a boat)



Thanks anyways though

 

[jon2]

I may have my old GS storm header. Looks just like the RTR header.

 

[Z400]

I may have my old GS storm header. Looks just like the RTR header.

I'm not sure if that will work or not


i would have to see a picture of it with a measuring tape/ ruler going from exhaust inlet to the outlet

 

[Scrogg]

It looks a lot like an Ofna buggy/truggy RTR header. I have one collecting dust upstairs. It's 80mm from end to end not including the mounting flange where the spring hooks in. Outlet is 10mm, inlet is 20mm. Inside diameters
No dents or gouges in it but it could use a good cleaning, a new coat of hi-temp paint if it is going on something pretty. If it is what you need I'll mail it to you next week. Mine is identical to yours judging from the pic.

 

[Z400]

It looks a lot like an Ofna buggy/truggy RTR header. I have one collecting dust upstairs. It's 80mm from end to end not including the mounting flange where the spring hooks in. Outlet is 10mm, inlet is 20mm. Inside diameters
No dents or gouges in it but it could use a good cleaning, a new coat of hi-temp paint if it is going on something pretty. If it is what you need I'll mail it to you next week. Mine is identical to yours judging from the pic.

Yes

i want it!

lol

Thank you!