• Welcome to RCTalk! 🚀

    Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!

    • ✓ Friendly & passionate RC enthusiasts
    • ✓ RC tips & troubleshooting
    • ✓ Buy, sell & trade RC gear
    • ✓ Share builds & upgrades

would my .21 pullstart work on picco 26

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
P

pissant

RCTalk Addict
Messages
1,154
Reaction score
0
Points
0
RC Driving Style
man it is so hard to get a pullstart for the picco 26, can i put on my .21 engine pull start?
 
But does the original 21bb pull starter fit on the picco outlaw? Is it nessesary to buy a new one?
 
The 21BB pullstart will fit but will only start it for about two to three pulls than will strip out due to it being plastic. Pissant if you have a roto start setup laying around it will work for you. I have been using it with no problems at all.
 
Yes I installed the roto system as well. Fires up with ease. Just crack the glow plug before to avoid breaking one way
 
Originally posted by toscano1
Just crack the glow plug before to avoid breaking one way
Click to expand...

Why does cracking your glow plug stop it from breaking? Would it be because its already broke?
 
It cuts some compression down so its easier to turn over. I do that too and the rotostart work pretty good.
 
Originally posted by scrible88
I'd think it would.
Click to expand...

Scribble have you tried it?? I did and it started to strip my 21BB pullstart out & would not work. Just to let you know my expereince.
 

RC Builds

Back
Top