will onfa work

[robby]

does anyone know if a onfa 3 shoe clutch kit will work on a .26 picco and will the flywheel be smaller than stock savage one. I want to run a 18th bell. does anyone know what will work with a 18th bell. i would like a better pipe to.

 

[TwiZtiD25]

I'm running my picco with a 3 shoe mugen cluth/flywheel kit and a 16T OFNA CB. Its been a great setup hooking up very strong. I can't comment on the OFNA kit, but a 18T CB will work with a little customizing on the TVP. As far as a pipe goes RB086, THS or RDLogics will perform very good.

 

[imnotsure]

i can comment on the 3 shoe from ofna. it doesn't work. the shaft is not long enough. from everything i've seen so far, you have to either figure out a way to make the shaft longer, (shims) or change out collet to set back further on motor. if you do this and find one, let me know.

 

[TwiZtiD25]

Shims dont make the shaft longer. Shims are for taking up extra space on the crankshaft. Like when you put everything on and you have extra play with the components on the crankshaft. Heres a LINK to the collet that gave me a little extra room on the crankshaft

 

[imnotsure]

you could of gave me that link the other day.thanks by the way a shim is a shim no matter were you put it "(take up space)"


never mind found stock collet it does not work need something else.