• Welcome to RCTalk! 🚀

    Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!

    • ✓ Friendly & passionate RC enthusiasts
    • ✓ RC tips & troubleshooting
    • ✓ Buy, sell & trade RC gear
    • ✓ Share builds & upgrades

When will I work the bugs out?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
C

crpresnell

RC Newbie
Messages
11
Reaction score
0
Points
0
Location
gaffney
RC Driving Style
  1. Racing
T-maxx Serious Bog!!!!!!!!!!

Alright guys. I went to my lhs today and puchased some new fuel line and an exhaust deflector for my 2.5 and when I started her up it would go pretty good till it hit second gear then it would bog way down and wouldnt hardly go and would not come out of 2nd gear. I tried adjusting the carb but I burnt the coils up on two glow plug in about 15 min. I was only adjusting the HSN. I have never touched the LSN. (Do you have to take the tank off to adjust the LSN or is there another way to get to it)? Someone plz help me I can't wait till I get all the bugs worked out of this thing so I can run it without worrying!!!
 
Last edited:
You can get to it without taking off the tank. I have a thin driver that came with a toolkit I got a while back that works good. Go to a hobby shop and get some small drivers.
 
well. i think you need to just practice on your tuning. that will get rid of all your bugs.. so lets see here. do you have a temp gun? that would make your tuning so much easer. make sure when you adjust, do small 1/8 incroments. also, start with the low speed and then go to the high.. your low speed is probly pretty close.. if you put a stinger on a pipe that origanelly didnt have one, it will run rich, so you have to re-tune for that as well..
 

RC Builds

Back
Top