• Welcome to RCTalk! 🚀

    Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!

    • ✓ Friendly & passionate RC enthusiasts
    • ✓ RC tips & troubleshooting
    • ✓ Buy, sell & trade RC gear
    • ✓ Share builds & upgrades

Werks .26 needle settings ?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
Help... Please.... lol It's basically the same mill as the Picco .26
 
If he is around you should talk to BillHoskinson as he has that mill last I checked. Good Luck.

Jon
 
Thanks for the help guys, but I finally got the damn thing running... I'll explain later, as I'm goin out to dinner to cool off... lol :flaming:
 
Well... After a few hours of trying to get this pig running, I decided to pull the carb off for a quick inspection... I found that the o-rings on the LSN were shredded up real bad. I found slivers of rubber stuck on the needle and in the port. Mind you, this is a brand new mill. Luckily, this mill comes with a spare high speed needle & o-rings. I stole those rings and reassembled... Waaalllaaa.... She's screamin like a raped ape...

I would like to thank Ratzo for his phone support in helping me solve this mystery... I know I'm not an ace at tuning, but this one was throwin me for a loop... :cheers:
 

RC Builds

Back
Top