Upgrade Advice???

[Outdoors2]

Howdy! My question: What to do next????? Here’s what I’ve done so far to my new TMaxx 3.3 for light backyard bashing and running around:

RPM A-Arms, Skid Plates, Bumpers, Axle Carriers, True-Track Rear
RC Raven Dual-Rate Springs
Traxxas Big Bore Shocks (50 wt. front, 45 wt. rear), Stainless Steel Hinge Pins
Venom 6V 1600mah Hump Pack & Peak Charger
Fuel Filter
Integy 3-point Roll Bar
Complete Ball Bearing Steering Bell Cranks

Thanks!!!

 

[Jacknifejuv]

Not much by the looks of id replace the stock air filter , upgrade the bulkheads , vented clutch bell and replace the stock clutch . And not much else lol . You got any picture's .

 

[theant]

chassis, wing, bulkheads, futaba servos/reveiver/radio, proline tires & wheels, proline body if you dont already have one. youve done alot to it already. the list can be as endless as the money is in your wallet.

 

[Jacknifejuv]

Agreed with theant , its never ending .

 

[Outdoors2]

Pics

Not much by the looks of id replace the stock air filter , upgrade the bulkheads , vented clutch bell and replace the stock clutch . And not much else lol . You got any picture's .

Thanks for your input! Here are a few pics of my truck.

 

[theant]

Nice!!!

 

[Jacknifejuv]

Sweet as

 

[mrferly2004]

ur truck is way too clean. there is no point upgrading to just not use it

 

[TraxxMaxx602]

kinda off topic but does that integy roll bar let you use an ignitor or does that "x" on top, sit center over the motor?.. i can't see from ur pics..

 

[Hopsingh]

since you have the rpm axle carriers then i would suggest, from my past experience, that you go ahead and get ready to have to "mod" them. If u are a basher then you will most likely end up having pillow balls popping out. rpm is a great product, best a arms on teh market. they are great because the plastic gives on impact instead of just snapping like stock. But this also makes for a slight downfall for the axle carriers. the plastic with give/flex slightly on impacts and allow the pillow ball to pop out. What i did to mine was take some carbon fiber tubing i found at a local company here and cut it into small rings and slid that on top of the axle carrier where the pillow ball goes in. I have also heard of people using brass tubing the same way.