Took the Fall

[Rolex]

I just finished setting it up with this one:
It no longer fits the extended chassis of the Savage, so it got a new place to sit.

 

[Radron]

A Rubi,Cool. Going for that scale look!

 

[Rolex]

The actual lid that came with it looks ridiculously small. I didn't care for it at all.

 

[flm_savage]

servo savers are ghey

 

[alpinehyperlite]

Heat sink for what?

 

[ajames942]

the motor dummy..lol

dont taze me bro

 

[h8z2luze]

Heat sink for what?

I would imagine its for heat


lol jk ya i dont think a crawler really needs a heatsink. And the servo saver might crap out your performance i would think.

 

[alpinehyperlite]

That was my point. Crawler motors wont get hot enough.
Then again, i guess rolex would have to run his rigs to realize that.

 

[ajames942]

Probably becuase it gets too hot in those glass cases

 

[h8z2luze]

one day he is going to post a pic with his savage just covered in mud along with the ax-10 and were all going to have a heart attack.

 

[Racer 1966]

As always, you do some nice looking work Rolex! But as for running in the dirt, well I'm in Missouri so SHOW-ME! :

 

[abadk9420]

Nice Rig wish I had one, and guess if you were concerned about getting it dirty you could clean up some rock realy well and make a crawler corse in clean room, LOL!!!

 

[h8z2luze]

Nice Rig wish I had one, and guess if you were concerned about getting it dirty you could clean up some rock realy well and make a crawler corse in clean room, LOL!!!

lmao i can see the vid now he starts to go up gets halfway up and spins and slides off cause the rocks and tires are coated with armorall.

 

[chuck3]

If he were to clean up a crawling area, we woudent be able to look at it during daylight hours. we would all be blinded by the rocks

 

[Rolex]

I can't leave you guys alone for more than a couple of hours without you getting on my case. :\

This is slick. Remove one screw and the entire mounting plate swings up to allow access to anything.

I removed the stock mounts laying there, and replaced them with longer ones to fit the wider body of the Ruby.

ACTION SHOTS!!!

Climbing the walls!

 

[abadk9420]

those pics are oubviously staged, I wont believe he has actully driven this rig till he post some video, LOL!!!!!

 

[Rolex]

LMAO! Those action shots are real! It was actually driven to those poses.
The heatsink gives it some bling.
What about the servo saver? Not needed on a crawler?

 

[abadk9420]

one day he is going to post a pic with his savage just covered in mud along with the ax-10 and were all going to have a heart attack.

Now we all know the only way he will ever get any dirt on his rigs is with Photo Shop, LOL!!!

 

[SmokeDogg]

What about the servo saver? Not needed on a crawler?

I dont think you will put yourself in the situation to need one with the crawler. Just a good strong servo should work fine.

Lookin good bud!

 

[NCNitro]

This is slick. Remove one screw and the entire mounting plate swings up to allow access to anything.

Makes it easier to dust huh.

The heatsink, he figured he already had the heavy duty shelving so the little extra weight on the shelf would be fine. But it will add a little time to the dusting, getting between all those fins.