ok, so i have just finished installing the FOC and i took ther truck out for a run, it was running great for about 10 mins but then it wouldn't drive. there was no throttle response from the servo at all and only a small amount for the brake. at the moment i am not running a fail safe ( and i know this is very bad, waiting for the postman) so i am not sure if it is low voltage or if the servo is cactus? any thoughts on the subject?
-
Welcome to RCTalk! 🚀
Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!
- ✓ Friendly & passionate RC enthusiasts
- ✓ RC tips & troubleshooting
- ✓ Buy, sell & trade RC gear
- ✓ Share builds & upgrades
throttle servo
- Thread starter andy_xr81
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
I'd try fresh batteries first.
Indian_Joker
RCTalk Rookie
- Messages
- 24
- Reaction score
- 0
- Points
- 0
- RC Driving Style
- Bashing
Yeah definitely try new batteries. I did'nt have much response on my throttle the other day after it sat all winter. Then realized I've never changed the batteries in the receiver since I bought it last summer. Changed the batteries works fine.
