throttle return spring install....

[scr2000]

I searched for this, I really did, and didn't come up with what I need so please help me if you can: Where on the T-Maxx 2.5 would I put the throttle return spring? I've only found info for the older Maxx (rotary carb).

 

[FSTFBDY]

I was havin the same problem lastnight on my Maxx with a Sirio .18

I still dont like the way it is and I'm gona end up doing it diff. If I find a good way I'll post pic's

 

[Domination]

i took mine off it was giving my more problems than helping i couldnt find a good position to put it in the spur is in a bad place IMO

 

[trible10]

If you're having problems or issues with your throttle return springs; just use a rubber band. All you have to do is put it around the throttle neck (the air filter opening) then over the tip of the throttle arm (the part that connects to the linkage). It works just as good as a throttle return spring, but less of a headache for me. I'll take some pics of mine if this sounds confusing.

 

[bigboystoysguy]

just use a fail safe much nicer to the servo and its less likely to break under heat and stress

 

[knall]

My throttle servo wont even open the throttle to WOT if the return spring has remotely enough pressure to actualy CLOSE the throttle and fight the servo.

 

[guys2nv]

on 2.5 motors-it has a return spring inside the boot-not sure about 3.3 motors.

 

[jerry7007]

on my 3.3 the spring is attached to the throttle linkage and the transmisson. theres just a hole drilled on the transmission case and the spings attached to that