-
Welcome to RCTalk! 🚀
Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!
- ✓ Friendly & passionate RC enthusiasts
- ✓ RC tips & troubleshooting
- ✓ Buy, sell & trade RC gear
- ✓ Share builds & upgrades
Thought boost would be fun!!!
- Thread starter TRAT
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
- Messages
- 13,168
- Reaction score
- 25,074
- Points
- 1,950
- Location
- Bomb Pop Island
- RC Driving Style
- Bashing
- Racing
Some duct tape should fix that. Use jb weld to seal it.
Tunedfrog
Kermit the frog is a sissy.
Supporter
Excellence Award
Hospitality Award
Military Veteran
Build Thread Contributor
RC Showcase: 10
- Messages
- 17,394
- Reaction score
- 37,853
- Points
- 1,875
- Location
- Idaho
- RC Driving Style
- Bashing
- Crawling
- Scale Builder
Slight blemish.
I bet that made some noise.
I bet that made some noise.
- Messages
- 13,168
- Reaction score
- 25,074
- Points
- 1,950
- Location
- Bomb Pop Island
- RC Driving Style
- Bashing
- Racing
Some knock knock jokes were the noise. They were not funny knock knock jokes at all.
Hornet49
RCTalk Rookie
What engine is that? Relief cuts in the pistons suggest a hemi dodge?
Man those cylinder walls seem thin.
Man those cylinder walls seem thin.
- Messages
- 13,168
- Reaction score
- 25,074
- Points
- 1,950
- Location
- Bomb Pop Island
- RC Driving Style
- Bashing
- Racing
Knock knock
Surprise
Surprise who
Surprise!
Surprise
Surprise who
Surprise!
- Messages
- 12,467
- Reaction score
- 29,143
- Points
- 1,933
- Location
- Jurassic Park
- RC Driving Style
- Bashing
- Crawling
- Scale Builder
Do we run it as a 7 cylinder or do we make it a 4 banger? 
- Messages
- 476
- Reaction score
- 1,192
- Points
- 210
- Location
- MN
- RC Driving Style
- Bashing
- Crawling
- Flying
- Boating
What left the chat? Usually the damage is caused by a connecting rod ejecting itself. The pistons are still in place. Too much compression? Crack in the block?
TRAT
Hardcore RCTalk User
- Messages
- 3,124
- Reaction score
- 4,607
- Points
- 545
- Location
- Hell
- RC Driving Style
- Bashing
- Racing
- Crawling
- Scale Builder
- Flying
- Thread starter
- #9
Or pre detonation. I seen this before on a boosted nitro car. Except it was aluminum block and bent the connecting rod into a perfect Z had to dig the piston out of the block. Was actually pretty cool. It was on. Aluminum V8 cut down to a V4 was my bosses wife’s drag rail. I asked him if I could keep the rod he said no
..
- Messages
- 741
- Reaction score
- 1,188
- Points
- 565
- Location
- Paris somewhere
- RC Driving Style
- Bashing
- Racing
- Scale Builder
I know what happened; you didn’t switch to electric in time!
