The .15 Velocity Needs Your Help!!!

[bluebr65]

ahhh!! hello all, i have a question. I have adjusted my low speed and high speed screws nicely, but when i start to open up the throttle to get top speed, the engine stalls!!! (around 30-40 mph) Some say its the high speed needle that needs adjusting, I'm gonna get a new low plug too becasue e one i was using was almost dead. But i dontthink the plug caused the stalls. Can anyone help me???

 

[GilBeQuick]

First try richening up the HSN 1/2 turn and see how your top end responds. If It just bogs down at speed then obviously it's too rich. If it improves at all then you're on to something and fine tune from there. If it makes the problem worse then your settings were probably too rich to begin with and turn it back in 1/2 turn to get where you started from, then lean it out in 1/8 turn increments and go from there.
Good luck and let us know if that helps at all.

 

[bluebr65]

thanx

Thanks so much man! I'm going ot ry all of that after school, or at least after the weather clears up. Dam, it takes so long for those glow ignitors to fully charge!

thanks
Bear