t maxx 3.3 break in

[Sweensta45]

ok i just got a 3.3 engine to replace my 2.5 engine had the hobby shop put it in for me. anyways i am on the 3rd tank in break in and it seems like its sluggish and does'nt have any get up and go and also idles high sometimes and i tried making adjustments. Is that how break in is or should it have decent acceleration by the 3rd tank?

 

[NitroRC4Life]

if you dont have good acceleration thn try to mess around with the lsn but only a little bit because its still break in but does it bog up and down or cut out with too much throttle??

 

[Sweensta45]

yes it does.

 

[NitroRC4Life]

it does what?

 

[Sweensta45]

it cuts out with more throttle.

 

[NitroRC4Life]

then try to lean it out a little bit cuz it sounds like your gettin to much gas

 

[Sweensta45]

ok i will try that its just i did that preety lean and i didnt want to mess anything up but ill try it again do you think it should have good acceleration if its on 3rd tank?

 

[NitroRC4Life]

ya it def should by the third cuz your more than halfway done, but if it doesn't get any better are the rpms at least getting high but the accel is bad?

 

[Sweensta45]

yes after a while it goes preety good and it would deff take off but it takes a good bit to get it rolling so the accel is real bad.

 

[NitroRC4Life]

its probably just your lsn tune

 

[Sweensta45]

ok thanks man i appreciate it.

 

[NitroRC4Life]

yea no problem

 

[Sweensta45]

i told you the same thing happen to me i tried turning it by hand to much compression if you take one of those glow plug ignitors it will get the glow plug real hot and when u do that then hit the ez start and it will fire up i have to do it to mine everytime during break in because it had to much compression.

my bad wrong post.