gangsta
RCTalk Basher
I'm already having trouble with the maxx i started it up and it wont acclerate forwood it will only go bak i flicked the switch a few times to see if it would change to forwood what is rong with it
-
Welcome to RCTalk! 🚀
Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!
- ✓ Friendly & passionate RC enthusiasts
- ✓ RC tips & troubleshooting
- ✓ Buy, sell & trade RC gear
- ✓ Share builds & upgrades
stuck in reverse
- Thread starter gangsta
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
- Messages
- 8,360
- Reaction score
- 12
- Points
- 723
- RC Driving Style
- Bashing
What switch did you flick a couple of times?
Have you checked to make certain your idle speed is not too high? If the idle speed is too high, the transmission will be too loaded up to shift from forward to reverse or vice versa.
Have you checked to make certain your idle speed is not too high? If the idle speed is too high, the transmission will be too loaded up to shift from forward to reverse or vice versa.
Yes, I found that out when I had my maxx. Also make sure that your servo is actually pulling the yoke in and out the tranny as well. But like Skymaxx said... if your are idling high... it will not let the tranny shift. Let us know.
Tom
Tom
- Messages
- 8,360
- Reaction score
- 12
- Points
- 723
- RC Driving Style
- Bashing
What switch exactly? There is a servo reversing switch...there is the reverse on the remote....there is the pushrod on the transmission...
You need to be more specific if you expect to get help on this.
Have you even checked the idle as asked before? If not, that would be the first place to start.