• Welcome to RCTalk! 🚀

    Join the #1 RC community where hobbyists connect, share, and get expert advice on RC cars, trucks, boats, drones, and more!

    • ✓ Friendly & passionate RC enthusiasts
    • ✓ RC tips & troubleshooting
    • ✓ Buy, sell & trade RC gear
    • ✓ Share builds & upgrades

Sticking at TDC

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
Tarant

Tarant

Hardcore RCTalk User
Messages
1,756
Reaction score
0
Points
0
Location
Medford
RC Driving Style
I just got my TRX piston and sleeve back from being resized and after a tank of fuel I was done I put in some afterrun oil and moved the flywheel with my finger and I noticed that my engine would stick in TDC what is wrong what should I do I dont want to run it and ruin it, any suggestions. it ran with a oild and clean motorsavers airfilter and I had rebuild the engine a few days ago.
 
well it sounds like your piston and sleeve are like new. So run through the break in process again.
 
It needs to be broken in again. You said it was resized, pinched right? You need to do the whole break-in process again.
 

RC Builds

Back
Top